Vibration pump may be uneven electric rotors, or coupling poor coupling, bearing wear and tear may also be rotating parts loose, rupture; may be due to the pipe bracket is not strong and so on. Can be taken to adjust, repair, reinforcement, replacement and other methods to deal with.
Pipe leaks or leaks may be installed screw nut is not tight. If the leakage is not serious, in the place of leakage or leakage coated with cement or asphalt mixing oil slurry. Temporary repair can be painted wet mud or soft soap. If leakage occurs at the connector, tighten the nut by hand. Leak serious must re-disassembly.
Overheating due to packing too much pressure is too tight, cooling water into the filler, or the shaft surface damage. Proper relaxation of packing can be taken to clear up the sealing tube blockage and other measures. Filler wear must be replaced by new ones. Soak it in the oil before installation, insert it in turn, and cut it off, which will reduce water leakage. After the last lap packing is installed, the gland should be installed tightly and the tightness should be adjusted during operation.
The pump does not absorb or not drain the main reason for the end of the valve stuck, part of the blockage of water filtration, water absorption is too high or water leakage may also be due to the wrong direction, impeller runner blockage and so on. After one by one inspection, respectively, to take the end of repair valve, remove the blockage, correct steering, cleaning impeller and other measures to deal with.
Pipe leaks or leaks may be installed screw nut is not tight. If the leakage is not serious, in the place of leakage or leakage coated with cement or asphalt mixing oil slurry. Temporary repair can be painted wet mud or soft soap. If leakage occurs at the connector, tighten the nut by hand. Leak serious must re-disassembly.
Overheating due to packing too much pressure is too tight, cooling water into the filler, or the shaft surface damage. Proper relaxation of packing can be taken to clear up the sealing tube blockage and other measures. Filler wear must be replaced by new ones. Soak it in the oil before installation, insert it in turn, and cut it off, which will reduce water leakage. After the last lap packing is installed, the gland should be installed tightly and the tightness should be adjusted during operation.
The pump does not absorb or not drain the main reason for the end of the valve stuck, part of the blockage of water filtration, water absorption is too high or water leakage may also be due to the wrong direction, impeller runner blockage and so on. After one by one inspection, respectively, to take the end of repair valve, remove the blockage, correct steering, cleaning impeller and other measures to deal with.
Matting Agent For Plastic Coatings
Matting Agent popular used for the matte plastic coatings. It is synthetic amorphous micronized precipitated silica appearing as white powder and for both solvent-based and water-based system. Advanced matting efficiency is achieved by using silica with high pore volume and by fine control of the particle size and particle size distribution. It provides a superior matting and flatting, excellent coating appearance and transparency, cost efficient, effective anti-settling agent and easy dispersion, smooth, abrasion resistant ï¬lms of high surface quality. Silica Matting Agent reduce the gloss of a variety of products including coatings, paints, inks, lacquers, varnishes, while providing lower viscosity and better flow capability.
Silica Matting Agent suitable used for plastic coatings. It provided high matting efficiency, excellent coating appearance and better transparency. As well as low oil absorption, easy dispersion and smoothly touch with minimal impact of viscosity.
Matting Agent For Plastic Coatings,Chemicals Powder 7631-86-9, Coating Additives 7631-86-9,Paint Additives Silica Dioxide
Guangzhou Quanxu Technology Co Ltd , https://www.inkjetcoating.com